Interro PDA to Pico

Yes and No.

 

THE PICO BASIC KIT

PicoScope 4-Channel Scope 4425 (AES# pt-PP919)

 

TEST LEADS

The new 4-channel Pico requires a ground connection for each test lead, the PDA only needed on 1 ground connection for all channels.

set of 4 Premium test leads 3M long (AES# pt-PP718)

All the small clips & probes and piercers that connect to the ends of your PDA and Vpro leads will connect to the end of the Pico leads.

 

SYNCH PROBE

Trigger Inductive Pickup w/Shrouded BNC (01-14-Pico)

 

AMP PROBES

The PDA amp probes should have BNC, you can connect those directly to the Pico.
They might look like these:

Low Current Probe with BNC (AES# 07-60-bnc)

High Amp Probe (AES# 07-600)

 

PDA IGNITION LEADS

The PDA Ignition leads use a round, mulit-pin connector, we do not have an adapter that will connect it to the Pico, therefore, cannot use them with the Pico.

 

We have two options we have:

Universal Secondary Kit (AES# 01-10)

Overview: http://www.aeswave.com/Universal-Secondary-Test-Lead-Kit-for-COP-DIS-HEI-Dist-p9174.html

 

Mixmaster kit with 4 pickup leads (AES# pt-PP361)

Overview: http://www.aeswave.com/Mixmaster-12-channel-ignition-signal-mixer-p8751.html

 

We might be able to make an adapter that will connect to the COP plates with the RCA connector to the Universal Secondary Kit (AES# 01-10).

 

All your Vpro items are bananas, to connect them to the Pico you would need this adapter:

Flexible Adapter -- Male BNC to Banana Sockets (AES# 08-88-M)

Overview: http://www.aeswave.com/AES-Flexible-Adapter-Banana-Sockets-to-BNC-Male-p8513.html

 

If you have something else in your kit let me know.

 

 

The Pico Basic Kit + Test Leads = 4-Channel 4425 Starter Kit  (AES# pt-PP921)

If you don't already have Amp Probes then it would be cheaper in the long run to get a 4-Channel 4425 Standard  Kit (AES# pt-PP923)

Overview: http://www.aeswave.com/4-channel-PicoScope-STANDARD-Diagnostic-Kit-p9276.html